FAAC HOME SHIELD - Control keypad; You have forgotten the keypad access code

The indicator light goes ON whenever a key is pressed, but
the control unit does not react.
• If the control unit is in MAINTENANCE PROGRAM mode
the (the control unit indicator light flashes continuously),
close the enclosure of all the system’s elements, and, then,
the control unit compartment.
• You are not near enough to the control unit.
Remote-control
Put the system in MAINTENANCE PROGRAM mode:
- simultaneously press push-buttons 1 and 2 of the remote-
control until the LED begins to flash.
- press the OFF Key until the control unit beeps,
- open the control unit’s battery compartment.
To restore the access code to the factory code (123456), a
partial reset of the control unit is necessary, and entails also
the deletion of all remote-controls and keypads: press for 30
seconds the EFF key in the MAINTENANCE PROGRAM
mode and then, re-associate the remote-controls and the
keypad.
You have forgotten the telephone
transmitter access code
The keypad is not activating the control unit.
• Check if the keypad is actually recognised by the control
unit.
• Check if communication to the control unit is effective and,
if necessary, move the keypad.
The keypad emits a series of beeps whenever the access
code is typed in.
• An incorrect code was typed in.
• Type in the access code again.
The keypad no longer prompts you to type in the access code.
• More than 3 incorrect codes were typed in.
• Wait for 2 minutes before typing the code in again.
The battery symbol is lighted.
• Replace the batteries of the control keypad.
Control keypad
Put the control unit in MAINTENANCE PROGRAM mode:
- simultaneously press push-buttons 1 and 2 of the remote-
control for 5 seconds until the LED begins to flash,
- press the OFF key until the control unit beeps
- open control unit compartment.
To restore the access code to the factory code (1234)
- open the keypad enclosure and remove the device from the
base,
- press the OK Key and then simultaneously press the three
top keys until an acoustic signal is heard.
You have forgotten the keypad
access code
Troubleshooting
40
Troubleshooting