Assembly Manual 01
Necessary tools
Factor Slick Aerobar Assembly
1-1
Torque wrench with 3, 4, 5mm hex & Torx T20 bits
BRT-002 bearing press from Enduro Bearings
Sand paper (120-180 grift)
Park Tool IR-1
Grease & Loctite 243 (dropouts) & 641
Isopropyl alcohol
Route the Di2 seatpost cable from seattube to the bottom
bracket (internal port). Connect to the Shimano Di2
Junction B according to Shimano’s instructions.
1-2
Note: Factor frame sets are shipped with 7X9 mm outer rail
clamps for carbon rail saddles. 7x7 mm outer rail
clamps for traditional saddle rails are available through your
Factor dealer.
round 7x7mm rails
oval 7x9mm rails
Similar to a Formula 1 car your Factor Slick requires a bit of patience and mechanical skill to achieve a truly impressive result.
We recommend that you have your bicycle assembled and maintained by an authorized Factor dealer. Make sure to let your
mechanic know how much you appreciate their help building the bike of your dreams!
Instructions
Seatpost
To Next Page
Loading...
