Faema E92 Elite - Installation Check-Up

WATER CONNECTIONS
No leaks from the connections or tubes
FUNCTIONING
Boiler and operating pressures are normal. 
The pressure gauge is working properly. 
The self-leveling device is working properly.
The expansion valves are working properly
6. Installation Check-up
WARNING$)7(5,167$//$7,21&+(&.726((,)7+(0$&+,1(,6:25.,1*3523(5/<VHHWKH
Installation Module C)
GROUPS
+RRNXSWKH¿OWHUKROGHUVWRWKHJURXSVZLWKRXWFRIIHH
Let each group dispense water for about a minute.
HOT WATER
Continuously dispense hot water (pressing the appropriate button) until at least 6 liters of water have been used for a ma-
chine with 2 groups, 9 liters for a machine with 3 groups and 12 liters for a machine with 4 groups (see the “Cleaning and
Maintenance” Chapter in the User’s Manual).
STEAM (also with Autosteam)
Dispense steam from the nozzles for about a minute, using the appropriate buttons.
CAPPUCCINO MAKER (automatic cappuccino maker device)
After removing the intake tube from the milk container, carry out a few test cycles.
WARNING: ONCE THE MACHINE HAS BEEN INSTALLED AND IS READY FOR USE, BEFORE ALLOWING THE
:25.(572 67$5786,1*7+(0$&+,1(:$6+7+(,17(51$/&20321(176$&&25',1*727+(
INSTRUCTIONS BELOW:
47
English