Faema E92 Elite - Maintenance, Cleaning, and Troubleshooting; Boiler Water Level and Rinsing

7KHPDFKLQHLV¿WWHGZLWKDVHULHVRIDXWRPDWLFOHYHOFRQWURO
devices to keep the water in the boiler at a pre-set level.
The indicator light (4) comes on when water enters the
boiler.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control
devices are not working correctly.
3XVKWKHPDQXDOERLOHUZDWHU¿OOOHYHU22), taking care not to
exceed the MAX level on the optic indicator (19).
13. Water level control of boiler
15. Cleaning
Cleaning the cappuccino maker
This operation must be made at the end of each working
day.
1. Fill a container with 0,5 litre of cold water and one dose of
liquid detergent (see product instructions).
2. Remove the suction (18d) tube from the milk container and
immerse it in the solution.
3. Press button (16) and repeat the operation until all the
detergent has been used up.
4. Disassemble the cappuccino maker (18):
Unscrew the knob (18b) and remove the cappuccino
maker (18).
Remove the cover.
Unscrew the ring nut of the knob (18b) and remove it.
Unscrew and remove the adjustment screw (18a).
Prepare another dose of detergent and clean each
piece.
Remove any residue with a sponge.
Reassemble the cappuccino maker.
5. Rinse, pumping out at least one litre of cold water.
!
Before operating the machine, perform a rinse of
the internal circuits and change the water in the
boiler.”
8.1 Changing the water in the internal groups circuits
5HPRYHWKH¿OWHUFDUULHUV of the distributor groups.
Via the continuous distribution key (30), empty the water
from each group for approximately one minute. Repeat this
operation twice.
8.2 Changing the water in the boiler
Ensure that the indication on the display corresponds to the
working pressure value.
.HHSWKHKRWZDWHUGLVWULEXWRUNH\13a - 13c) pressed down
for approximately 5 seconds.
The following message will be displayed: “WATER CHANGE”,
followed by an audio signal. The water from the boiler will
drain from the hot water nozzle (10) (60 - 70% ca. of the total
capacity).
The boiler resistance and all dispensing keys will be
disabled.
14. Rinsing
10
13c
13b
13a
30
21/25
Dispensing will stop automatically (Note. The delivery can be
interrupted in whichever moment by means of the push button
STOP 13b).
After the procedure, the machine will return to its normal fun-
FWLRQVDQGWKHERLOHUZLOOEHUH¿OOHGZLWKIUHVFKZDWHU
18
18d
18b
18a
16
53
English