Faema E92 Elite - Page 24

Programming measures using the “SELF-LEARNING”
function: milk dose
To memorize the programming of the milk dose, follow the
procedure herebelow:
1) Place the cup by the cappuccino maker (18).
2) Press the “+” (34) key; the following message will appear
on the display:
3) Press the PROG (32) key; the following message will
appear on the display:
when modifying data, the cursor changes to " Æ".
ÀKEY MENU
Milk dose 03.6s
+
Æ
.HHSWKHGLVWULEXWRUNH\SUHVVHGDVHYLGHQFHGE\WKH
 ÀDVKLQJOHGWKHFRIIHHGRVHFRXQWHUVWDUWVIURP]HURDQG
increases in value).
5) When the quantity of milk in the cup has reached the
desired level, release the key (the counter will indicate the
rime that correspond to the set dose).
It is also possible to vary the milk dose or set the dose using
the “+” (34) and “-” keys (35).
N.B.: If the coffee dose is set to “00.0”, the key may only be
used for coffee distribution.
When the key (33) is pressed, the following message
is again displayed:
Programming measures using the “SELF-LEARNING”
function: coffee dose
To perform the coffee dose programming, follow the procedure
herebelow:
1)
)LOOWKH¿OWHUFDUULHU21) with the correct dose of ground coffee)
and insert into the group ensuring it is correctly locked in place
(do not use previously used coffee grounds).
3ODFHWKHFXSE\WKH¿OWHUFDUULHUVSRXW21).
3) Press the “+” (34) key; the following message will
appear on the display:
4) Press the PROG (32) key; the following message will
appear on the display:
when modifying data, the cursor changes to " Æ".
.HHSWKHGLVWULEXWRUNH\SUHVVHGDVHYLGHQFHGE\WKH
ÀDVKLQJOHGWKHFRIIHHGRVHFRXQWHUVWDUWVIURP]HURDQG
increases in value).
6) When the quantity of the coffee in the cup has reached the
desired level, release the key (the counter will indicate the
number of pulses that correspond to the set dose).
It is also possible to vary the coffee doses or set the dose using
the “+” (34) and “-” keys (35).
When the key (33) is pressed, the following message
is again displayed:
(**) Start milk/Start coffee function
By setting:
"Start milk 00" - milk dispensing takes place when the selection
key is pressed. After a few seconds, coffee is dispensed;
"Start milk 99" or at a high setting that exceeds the coffee
dispensing time - milk dispensing starts after coffee is
dispensed.
"Start milk 05" - coffee dispensing starts, and 5 seconds after
the selection key is pressed, milk is dispensed.
Note: If the time setting exceeds the coffee dispensing time, milk
dispensing begins immediately after coffee is dispensed.
"Start coffee 00" - Coffee dispensing starts after milk is
dispensed.
"Start coffee 99" or any setting other than 0 - coffee dispensing
will start 99 seconds (or after the set time) after milk is
dispensed.
The cappuccino beverage can be made as follows:
- First dispensing coffee and then milk.
- First dispensing milk and then coffee.
You can use the"+" (34) and "-" (35) keys to change the "Start milk"
setting (milk dispensing start delayed after coffee dispensing and
vice versa) from "00" to "99" with "1" second increments.
If over "99" is set, the "Start milk" setting will become the
"Start coffee" setting (coffee dispensing start delayed after
the milk dispensing), then the setting returns to "Start milk"
in a cycle.
ÀKEY MENU
Milk dose 03.6s
+
ÀKEY MENU
Milk dose 03.6s
+
ÀKEY MENU
Water dose 090
+
ÀKEY MENU
Water dose 090
+
Æ
The default settings for
cappuccino selections are:
Start milk 00.
Start Milk
Start Coffee
00 99
0099
ÀKEY MENU
Water dose 090
+
61
English