02/05/2020 25
SERVICE MANUAL
CONVEYOR BELT
19. INSTALLATION INSTRUCTIONS
The placement, installation, repairs and/or modifications must always be
carried out by an authorised technician in accordance with the
manufacturer's instructions and the applicable regulations.
Any installations, adjustments or repairs carried out by unauthorised
personnel, incorrect maintenance or use, the use of spare parts other than
those supplied by the manufacturer and any other type of alteration to the
appliance may cause damage or injury and result in loss of cover under the
THE MANUFACTURER MAY NOT BE HELD LIABLE FOR ANY PROPERTY
DAMAGE OR PERSONAL INJURY RESULTING FROM THE INCORRECT
INSTALLATION, USE, MAINTENANCE OR REPAIR, OR CAUSED BY FAILURE
TO COMPLY WITH THE STANDARDS AND INSTRUCTIONS PROVIDED.
19.1. POSITIONING AND LEVELLING
Fagor Industrial recommends that the place where the appliance is to be installed should be analysed
prior to installation to check that it is suitable.
The installation location must be able to withstand the weight of the
machine.
The height of the legs can be adjusted by turning them to ensure that the
appliance is correctly installed. It is essential that the machine is correctly
levelled.
Electrical cables, water and drainage hoses must not be trapped or contain
kinks.
Turn the leg clockwise to extend and anticlockwise to shorten.
The installation of this appliance requires electrical and hydraulic connections, and an adequate
ventilation/extraction system due to the steam emitted by the machine.
To Next Page
Loading...
