Fagor CCO-180 - User Manual

Questions and Answers

V
Veronica EvansAug 8, 2025
What to do if water does not enter my Fagor CCO-180?
- T
  Taylor HodgesAug 8, 2025
  If water isn't entering your Fagor Dishwasher, first check if there's water in the main system and ensure the shut-off valve is open. Additionally, try cleaning the nozzles. If these steps don't resolve the issue, it is recommended to call the technical service to have the appliance cleaned, the solenoid valve filter cleaned, the faulty solenoid valve replaced or the broken pressostat replaced.
B
Brian HudsonAug 13, 2025
Why are my dishes not drying in my Fagor Dishwasher?
- K
  krystal28Aug 13, 2025
  If your dishes and kitchenware are not drying properly in your Fagor Dishwasher, there might be several reasons. First, ensure that the rinse aid container is full. If the problem persists, the rinse aid dispenser might need to be reset by a technical service. Also, remove the dishes at the end of the wash cycle and allow them to air dry for a minute. The rinse temperature should be at least 80°C / 176°F. Allow the boiler to reach this temperature before starting the cycle.
S
Steven DennisAug 18, 2025
Why are my dishes stained or scratched after using my Fagor CCO-180?
- I
  Isaac ReedAug 18, 2025
  If your dishes are stained or scratched after washing in your Fagor Dishwasher, it could be due to several factors. If there is too much rinse aid, you may need to call the technical service to reset the dispenser. Check the water hardness; it should be less than 10 ºfH. Also, if you're using salt, be careful not to spill any in the tub when filling the salt deposit, and clean thoroughly if spillage occurs.
L
Logan HartAug 22, 2025
How to troubleshoot power issues with my Fagor CCO-180 Dishwasher?
- D
  Daniel PooleAug 23, 2025
  If your Fagor Dishwasher isn't receiving power, check whether the magneto-thermal circuit breaker or the differential switch has tripped. Also, check whether the emergency button is activated.
G
Gary StevensonAug 28, 2025
What to do if my Fagor Dishwasher stops mid-cycle?
- T
  Thomas PerezAug 28, 2025
  If your Fagor Dishwasher stops during operation, check whether the magneto-thermal circuit breaker or the differential switch has tripped. You can also try resetting the safety device. If it trips again, it is recommended to call the technical service.
L
Laura PayneSep 2, 2025
What to do if my Fagor CCO-180 stops and fills with water during washing?
- R
  Rebecca MartinezSep 2, 2025
  If your Fagor Dishwasher stops and fills with water during the wash cycle, ensure the overflow is correctly mounted. If it is, the pressure switch pipe may be blocked; empty the tub and clean it thoroughly. If the problem continues, the pressure switch may be faulty, in this case you should call the technical service to replace it.