Fagor CCO-120 User Manual

79 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

CONVEYOR DISHWASHERS

Service Manual

SERVICE MANUAL

“CONVEYOR DISHWASHERS”

02/05/2020

Table of Contents

Questions and Answers:

J
Jennifer BarnesAug 5, 2025
What to do if water does not enter my Fagor CCO-120?
- A
  andrea90Aug 5, 2025
  If water isn't entering your Fagor Dishwasher, first check if there's water in the main system and ensure the shut-off valve is open. Additionally, try cleaning the nozzles. If these steps don't resolve the issue, it is recommended to call the technical service to have the appliance cleaned, the solenoid valve filter cleaned, the faulty solenoid valve replaced or the broken pressostat replaced.
C
Cody DayAug 10, 2025
Why are my dishes not drying in my Fagor CCO-120 Dishwasher?
- T
  Travis LeeAug 10, 2025
  If your dishes and kitchenware are not drying properly in your Fagor Dishwasher, there might be several reasons. First, ensure that the rinse aid container is full. If the problem persists, the rinse aid dispenser might need to be reset by a technical service. Also, remove the dishes at the end of the wash cycle and allow them to air dry for a minute. The rinse temperature should be at least 80°C / 176°F. Allow the boiler to reach this temperature before starting the cycle.
R
ryanthompsonAug 15, 2025
Why are my dishes stained or scratched after using my Fagor CCO-120?
- B
  Brenda MorrisAug 15, 2025
  If your dishes are stained or scratched after washing in your Fagor Dishwasher, it could be due to several factors. If there is too much rinse aid, you may need to call the technical service to reset the dispenser. Check the water hardness; it should be less than 10 ºfH. Also, if you're using salt, be careful not to spill any in the tub when filling the salt deposit, and clean thoroughly if spillage occurs.
J
Javier FigueroaAug 19, 2025
How to troubleshoot power issues with my Fagor CCO-120 Dishwasher?
- D
  Devin AllenAug 19, 2025
  If your Fagor Dishwasher isn't receiving power, check whether the magneto-thermal circuit breaker or the differential switch has tripped. Also, check whether the emergency button is activated.
X
xtranAug 26, 2025
What to do if my Fagor CCO-120 stops mid-cycle?
- K
  kingmonicaAug 26, 2025
  If your Fagor Dishwasher stops during operation, check whether the magneto-thermal circuit breaker or the differential switch has tripped. You can also try resetting the safety device. If it trips again, it is recommended to call the technical service.
C
Christy LopezAug 30, 2025
What to do if my Fagor CCO-120 Dishwasher stops and fills with water during washing?
- W
  William ZimmermanAug 30, 2025
  If your Fagor Dishwasher stops and fills with water during the wash cycle, ensure the overflow is correctly mounted. If it is, the pressure switch pipe may be blocked; empty the tub and clean it thoroughly. If the problem continues, the pressure switch may be faulty, in this case you should call the technical service to replace it.

Fagor CCO-120 Specifications

General

Brand	Fagor
Model	CCO-120
Category	Dishwasher
Language	English

Summary

1. INTRODUCTION

4. PICTOGRAMS

5. UPKEEP

6. PROLONGED PERIOD OF INACTIVITY

7. MAINTENANCE

7.1. DAILY MAINTENANCE

7.2. REGULAR CHECKS PERFORMED BY THE USER

7.3. EVERYDAY CLEANING

7.4. SPECIALISED MAINTENANCE

8. HYGIENE REGULATIONS

9. REMOVAL OF PACKAGING

9.1. RECYCLING

Guidelines for proper disposal and recycling of packaging materials and the appliance.

10. GENERAL INFORMATION AND WARNINGS

11. USE

12. MODELS AND VERSIONS

13. DIMENSIONS

13.1. CCO-120, CCO-160, CCO-120 ECO and CCO-160 ECO

Dimensional specifications for specific compact conveyor dishwasher models.

13.2. CCO-120 and CCO-160 + CDT-600, CCO-120 ECO and CCO-160 ECO + CDT-600

Dimensional specifications for compact models with drying tunnel.

13.3. CCO-180 and CCO-225 + CDT-600, CCO-270 and CCO-320 + CDT-600, CCO-180 ECO and CCO-225 ECO + CDT-600, CCO-270 ECO and CCO-320 ECO +CDT-600

14. COMPOSITION

15. TECHNICAL DATA

16. CONNECTIONS

16.1. CCO-120 and CCO-160, CCO-120 and CCO-160 + CDT-600, CCO-1

Electrical connection points for CCO-120/160 models and variants.

16.2. CCO-120 ECO and CCO-160 ECO, CCO-120 ECO and CCO-160 ECO + CDT-600, CCO-1

16.3. CCO-180 and CCO-225 + CDT-600, CCO-270 and CCO-320 + CDT-800, CCO-180 ECO and CCO-225 ECO +CDT-600, CCO-270 ECO and CCO-320 ECO + CDT-800

17. SAFETY ASPECTS OF THE MACHINE

18. PRODUCT DETAILS

19. INSTALLATION INSTRUCTIONS

19.1. POSITIONING AND LEVELLING

Guidelines for properly positioning and leveling the dishwasher for installation.

19.2. ELECTRICAL CONNECTION

19.3. POWERS

19.4. HYDRAULIC CONNECTION

19.5. CONNECTION OF ECO MODELS

19.6. DRAIN CONNECTION

19.7. DISPENSERS (DETERGENT/RINSE AID)

19.7.1. DISPENSER HYDRAULIC CONNECTION

Procedure for the hydraulic connection of external detergent/rinse aid dispensers.

19.8.2. DETERGENT DISPENSER

19.8.3. RINSE AID DISPENSER

19.8.4. FEEDERS' ELECTRICAL CONNECTION

19.9. LIMIT SWITCH/MICRO SWITCH

19.10. EXTRA EMERGENCY BUTTON

20. SAFETY LOCKING SYSTEM

21. DOOR LOCKING SYSTEM

22. HYGIENE REGULATIONS

23. ALTERNATE (ALT) / SIMULTANEOUS (SIM) HEATING

24. INITIAL START-UP (AUTHORISED INSTALLER/TECHNICIAN)

24.1. FIRST FILL AND ACTIVATION OF THE BOILER

Procedure for the initial filling and activation of the boiler during start-up.

24.2. CONFIGURATION OF HEATING TEMPERATURES

25. DETAILS OF INTEREST

26. CONTROL PANEL

27. PREPARATION AND SWITCHING ON THE MACHINE

27.1. PREPARATION OF THE DISH

Correct preparation of dishes before loading into the dishwasher baskets.

27.2. WASH SPEED SELECTION

28. DIN 10534 standard

29. WASH PROCESS

30. HYDRAULIC DIAGRAM OF CONVEYOR BELT DISHWASHER

31. FUNCTIONAL DIAGRAM OF CONVEYOR BELT DISHWASHER

32. WASH CYCLE

32.1. INTERRUMPING THE WASH PROCESS

Methods for safely interrupting the wash cycle and restarting the machine.

32.2. DRAINAGE AND SWITCHING OFF THE MACHINE

Procedures for draining the machine and switching it off at the end of the day.

33. TROUBLESHOOTING

34. MOST IMPORTANT COMPONENTS

34.1. DRYING

Details of the drying tunnel components for specific conveyor dishwasher models.

34.2. ENERGY RECOVERY SYSTEM

34.3. CONVEYOR MOTOR

34.4. FREQUENCY VARIATOR FOR CONVEYOR MOTOR

34.4.1. FREQUENCY VARIATOR PARAMETERS

34.5. 230 V AC 50/60 HZ 8ª 8 WAY PROGRAMMABLE RELAY

34.6. 230 V AC 1 N 50 HZ 590 KW MOTORPUMP

34.7. 230-400 V AC 50 HZ MOTORPUMP

34.8. 230-400 V AC 50 HZ MOTORPUMP

34.9. TEMPERATURE CONTROL 230 V50/60 Hz 1 REL.

35. ACCESSORIES

35.1. SPLASH GUARD SUPPLEMENT

Description and benefits of the splash guard supplement accessory.

35.2. DRYING TUNNEL

35.3. ENERGY RECOVERY SYSTEM

36. ELECTRICAL DIAGRAM

37. ASSEMBLY ELECTRIC DIAGRAM

37.1. MODULAR CCO-120, CCO-120 ECO, CCO-160 & CCO-160 ECO

Assembly electric diagram for modular CCO-120/160 ECO and standard models.

37.2. COMPACT CCO-180, CCO-180 ECO, CCO-225, CCO-225 ECO, CCO-270, CCO-270 ECO, CCO-320 & CCO-320 ECO

Related product manuals

Preview: Fagor EVOconcept CCO-120DCW

Fagor EVOconcept CCO-120DCW

Fagor COP-504 W

Preview: Fagor Evo COP-174W

Fagor Evo COP-174W

Fagor Evo CO-502 W

Fagor Evo CO-402 W

Preview: Fagor Evo Concept Series

Fagor Evo Concept Series