02/05/2020 31
SERVICE MANUAL
CONVEYOR BELT
If using water at temperatures below 15 ºC / 59 ºF, the appliance must have a simultaneous heating connection
SIM. The default setting of the appliance is set to alternate heating. If simultaneous heating is required
(simultaneous heating of the drum and the wash tank), it is necessary to change the setting.
For the correct hydraulic installation of the machine, you must:
• Make sure that the water does not contain waste (new installation, etc.). Therefore before connecting the
appliance to the mains, run the water through the drainage until it comes out clean to avoid blocking the
appliance filter.
• Connect the appliance to a water supply which complies with the requirements specified above. All the
machines have a 3/4
” screw-on water hose connection. Old or used hoses must NOT be used. Connect the
To Next Page
Loading...
