02/05/2020 37
SERVICE MANUAL
CONVEYOR BELT
The system is adjusted using springs (1 or 2) mounted on the
module where the drive motor is located.
A spring and screw are supplied with the appliance.
Locate the module where the drive motor is mounted and remove the
corresponding lower front panel.
First remove the panel fastening bolts and lift the door.
Turn the front panel slightly upwards at the lower part and then
remove.
Locate the existing spring and mount the new spring in the adjacent
space. The spring which is now mounted can be released to make
the task easier. Take care not to over-tighten the bolts and break or
damage the safety lock detector switch (see circle in image below).
VERY IMPORTANT: the springs must be compressed to a length of
44 mm.
IMPORTANT: The springs must be compressed to a length of 44 mm in order to function
correctly.
This is the interior measurement. The thickness of the plates must be added if measuring
the outer part.
To Next Page
Loading...
