02/05/2020 34
SERVICE MANUAL
CONVEYOR BELT
19.8. DISPENSERS (DETERGENT/RINSE AID)
The appliance does not have detergent and rinse aid dispensers, but is designed to
permit the installation of external dispensers. The correct dispensers must be installed
and the correct detergent and rinse aid dispensers used to ensure optimum washing and
cleaning. Otherwise this is not guaranteed.
To complete this installation, the dishwasher must be switched off at the mains using
the disconnection switch and the mains switch, and the water inlet tap closed.
The following installation and adjustment must be carried out by authorised and qualified
personnel.
Contact a qualified chemical product supplier to determine the most suitable product and
dose in order to optimise the wash.
The guarantee does not cover damage caused by the incorrect installation or use of
dispensers and chemical products.
The correct selection and dosing of detergent and rinse aid is essential for obtaining an optimum wash. At the start of
the work day, check that the quantity of product in the reservoirs is enough for the daily requirement.
Only use liquid or solid detergent specially designed for use with industrial dishwashers and which is non-foaming at
high temperatures. Detergents designed for domestic use should not be used under any circumstances.
The results of the wash should be assessed after two fills and at least three wash cycles in order to stabilise the
doses. There should not be any foam in the tub after running the cycles.
Rinse aid is necessary to correctly disperse and drain the water over the dishes in order to avoid stains and to speed
up the drying process.
Scratched dishes and the formation of foam in the wash solution are usually an indication of excess rinse aid. Dishes
with too many water drops or which are slow to dry are usually a sign of insufficient rinse aid.
19.8.1. DISPENSER HYDRAULIC CONNECTION
For the hydraulic connection of the dispensers, remove the lower
front panel of the appliance.
- First remove the panel fastening bolts and lift the door.
- Turn the front panel slightly upwards at the lower part and
then remove.
-
To insert the pipes, use the bushing located in the lower
central part of the appliance.
To Next Page
Loading...
