02/05/2020 43
SERVICE MANUAL
CONVEYOR BELT
FACTORY ELECTRICAL SETTING
24. INITIAL START-UP (AUTHORISED INSTALLER/TECHNICIAN)
Before starting the appliance, use a functional test to check that the electrical protection system is operating correctly.
The machine must have been installed and/or inspected by qualified personnel, who will start the machine for the first
time, check the appliance operates correctly and provide the operating instructions to the user.
The manufacturer does not accept responsibility for an incorrect installation or start-up.
Before switching on the machine, check that the wash distributors, filters and trays are correctly positioned.
24.1. FIRST FILL AND ACTIVATION OF THE BOILER
BEFORE DRAINING THE BOILER, THE RINSE TEMP DISPLAY MUST ALWAYS BE
DEACTIVATED.
THIS OPERATION MUST ALWAYS BE PERFORMED AFTER DRAINING THE DRUM.
THE MANUFACTURER DOES NOT ACCEPT ANY RESPONSIBILITY FOR PROPERTY
DAMAGE OR PERSONAL INJURY RESULTING FROM THE NON-COMPLIANCE OF THE
Activate the magneto-thermal switch and set the mains switch IG to ON.
Open the water shut-off valve.
Using the SELECT switch, select position I, II or III. The WASH TEMP display lights up and water starts to fill the
appliance.
VERY IMPORTANT: As this is the first fill, the drum will be empty and the drum heating must not be activated; the
RINSE TEMP display must continue switched off.
To Next Page
Loading...
