02/05/2020 47
SERVICE MANUAL
CONVEYOR BELT
26. CONTROL PANEL
Serigraphy models CCO-120, CCO-160, CCO-180, CCO-225, CCO-270 and CCO-320
Serigraphy models CCO-120 ECO, CCO-160 ECO, CCO-180 ECO, CCO-225 ECO, CCO-270 ECO and CCO-320 ECO
27. PREPARATION AND SWITCHING ON THE MACHINE
Before switching on the machine:
Make sure that the machine is clean (filters, trays, distributors, arms
…).
Make sure that elements such as filters, trays, distributors, arms, overflow and curtains are correctly
mounted in their respective positions. (Long curtains at the exits and short curtains in the interior).
Open the water mains tap and check that there is water.
Close the doors of the appliance.
Activate the magneto-thermal switch and set the mains switch IG to ON. If there is no current, check that the
emergency button has not been pressed.
To start filling the machine, it is essential that the door is totally closed.
The appliance does not operate if it detects that the door is open.
Using the SELECT switch, select position I, II or III. The WASH TEMP and RINSE TEMP displays light up and water
starts to fill the appliance.
The fill and machine preheating processes take place. This process may last about 30 minutes.
To Next Page
Loading...
