Fagor CNC 8055 T - Programming Examples: Canned Cycles; Canned Cycles

11
Programming examples:
Canned cycles
8055T
Inside turning of arcs and outside turning of straight sections. .................... 12
Inside arc facing and outside straight turning. ........................................... 14
Inside straight facing and outside arc facing. ............................................. 16
Inside roughing on the Z axis and outside arc turning. ................................ 18
Inside straight turning and outside roughing on the Z axis. ......................... 20
Inside and outside roughing on the X axis. ................................................ 22
Inside and outside taper threading. .......................................................... 24
Inside and outside roughing on X. Outside grooving and threading. .............. 26
Outside pattern repeat. Inside grooving and threading. ............................... 28
Inside and outside roughing on the X axis ................................................. 30