Quick reference
28
(SOFT 03.1X)
#PROBE 9. Circular boss measuring.
#PROBE 9 X Y Z B J E <C> H F
X..Z Coordinates of the boss center.
B Safety distance.
J Theoretical boss diameter.
E Withdrawal distance after initial probing.
C Point where the probing cycle ends.
• "C"=0: the probe returns to the point from where
the cycle was called.
• "C"=1: the cycle ends by positioning the probe
at the real center of the boss, at a "B"
distance from the programmed
coordinate.
H Feedrate for the initial probing movement.
F Probing feedrate.
#PROBE 10. Rectangular part centering
#PROBE 10 <X Y Z> I J <K> <L> <B> D E <H>
<F> <Q>
X..Z Probe position when calling the cycle.
I Part length along the abscissa axis.
J Part length along the ordinate axis.
K Axis and direction of the first probing movement.:
• "K"=0: the probe moves in the positive direction
of the X axis.
• "K"=1: the probe moves in the negative direction
of the X axis.
• "K"=2: the probe moves in the positive direction
of the Y axis.
• "K"=3: the probe moves in the negative direction
of the Y axis.
L Surface coordinate measuring:
• "L"=0: the cycle does not measure the surface
coordinate.
• "L"=1: the cycle measures the surface
coordinate.
B Safety distance.
D Safety distance along Z.
E Withdrawal distance after initial probing.
H Feedrate for the initial probing movement.
F Probing feedrate.
Q Feedrate for approach movements.
Z
To Next Page
Loading...
