39
13.3 BOILER THERMOSTAT
Part number: Z203014
Notes: Be sure that thermostat is full open, in order to get the proper sanitized rinsing temperature
(195ºF) . Turn it clockwise up to the end.
TOOLS NEEDED:
Phillips Screwdriver (#2)
10mm Nut driver
PROCEDURE:
1- Remove lower front panel
2- Remove thermostat from support bracket
3- Pull out sensor from boiler
4- Replace with new component
5- Reconnect & reassemble following process inversely
Time estimated
: 15 minutes
13.4 TIMER
Part number: Z228412 (FI-48W) / Z258412 (FI-64W)
TOOLS NEEDED:
Phillips Screwdriver (#2)
PROCEDURE:
1- Slide out front panel
2- If accessibility is not good enough, remove top lid.
3- Write down connections (colours) on the timer, before
Removing.
4- Take out timer
5- Remove the electrical connections
6- Replace with new component
7- Reconnect connections with the help of your notes
8- Reassemble following process inversely
Time estimated: 15 minutes
To Next Page
Loading...
