Falcon 110 - Page 32

English
32
Remove the two fixing screws (3mm hexagonal socket
head) and nuts that pass through the top of the rear flue
grille. Hold the splash back in position. From the rear refit
the 2 fixing screws and nuts.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations and also the local
electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a dou-
ble pole switch having a contact separation of at least
3mm in all poles. This cooker must not be connected to an
ordinary domestic power point.
The total electrical load of the appliance is approximately
15.6kW. The cable size used should be suitable for this
load and comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for your
electrical supply type. Please note the maximum cable
sizes are 6mm
2
for the screw terminals and 10mm
2
for the
3 pronged links.
Check that the links are correctly fitted and that the termi-
nal screws are tight. Secure the mains cable using the ca-
ble clamp.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fit each end keyhole over their respective
screws. Tighten the fixing screws.
Oven Light
Press the oven light switch and check that the light is
working.
NB The oven light bulb is not included in the guarantee
Hobplate
Turn on each plate in turn and check that it heats up.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
The clock must be set to the time of day before the ovens
will work.
Press and hold as shown.
At the same time, press - or + until the correct time shows.
Don’t forget it’s a 24-hour clock.
If you make a mistake or press the wrong button, turn off
the power supply for a minute or two and start again.
Turn on the oven and check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the oven.
Customer care
Please complete your details in this Guide, inform the user
how to operate the cooker and hand over the Instructions.
Thank you.