FANATEC CSL - Incorrect In-game Pedal Behavior; PC Booting Issues with USB Connection; Contacting Customer Support

16 16
Problem description Solution
Pedal signal of the CSL Pedals and / or CSL
Pedals LC in-game behaviour feels incorrect.
Connect the CSL Pedals LC to a PC or a
wheel base. Start the Fanatec Control Panel
and check the indicator bars of each pedal
while pressing each corresponding pedal.
You may need to do a manual calibration
of minimum and / or maximum positions or
reselect
‘...Manual Mode’ to adjust the pedal
signal behaviour as desired.
After startup the CSL Pedals and / or CSL
Pedals LC pedal signals are not correctly
indicated, can be veried in the Fanatec
Control Panel.
When powering ON the CSL Pedals LC
without ‘...Manual Mode’ selected, every
pedal lever must rst be pressed to the
maximum position and then back to the
minimum position. The signal of each
pedal should be ne.
See section 4.5
“Tuning Options”, “Manual Mode”
Your PC does not boot when the CSL
Pedals LC is connected via USB before
Windows has booted.
This phenomenon is related to some main
board manufacturers’ BIOS. In this case, it is
required to boot the PC rst and then connect
the CSL Pedals LC via USB.
How can I get in contact with Fanatec
customer support?
There is a chat service on our website, or
you can create a Support Ticket via the ‘My
Products’ section of your Fanatec account.
Fanatec.com