fantastic furniture Java Console Table - 9

Step 6
Page 9fantasticfurniture.com.au
You will need
Phillips Head
Screwdriver
6 x Screws
12mm (H18)
2 x Slide
Tracks (H19-1)
Mallet
H19-1
Note the position
of the rubber stopper
Insert 4 x dowels (H3) into divider panel (P4) as shown.
If needed use a mallet to gently tap the dowels into place.
Attach 1 x slide track (H19-1) onto the side of divider panel (P4) without cam nut holes
using 3 x screws (H18) as shown.
Turn divider panel (P8) over.
Attach 1 x slide track (H19-1) onto divider panel (P4) with 3 x screws (H18) as shown,
using a phillips head screwdriver.
It is important to note that the screws on this side need to be fixed into dierent holes
compared to the slide track (H19-1) on the other side of the divider panel (P4).
H19-1
4 x Dowels
30mm (H3)
H18
(P4)
H3
H18
Important Note:
The screws need to be fixed
into dierent holes compared
to the other side.
H19-1
H19-1
H3
H3
H3
H19-1
H19-1
H18
H18
H18
H18
(P4)
Please fasten the screws through
these holes for this step
Please fasten the screws through
these holes for this step