□ Quick Power On Self Test
Select “Quick Power On Self Test” Enabled/Disabled.
□ First/Second/Third Boot Device
Select boot device priority.
□ Boot Other Device
Select “Boot Other Device” Enabled/Disabled.
□ Boot Up NumLock Status
Select <NumLock> key ON/Off when system boot up.
□ Gate A20 Option
Select Gate A20 controlled by Keyboard controller (Normal) or Port 92 (Fast).
□ Typematic Rate Setting
Select “Typematic Rate Setting” Enabled to set,
Typematic Rate (Chars/Sec): Number of characters repeated in one second.
Typematic Delay (Msec): When holding one key, set the time between the first and
second character displayed.
□ Security Option
Select security mode,
Setup: Require password to permit BIOS setup utility.
System: Require password to permit boot-up and BIOS setup utility.
□ OS Select For DRAM > 64M
Select “OS2” only if you are running older version of IBM OS/2 Operating System with
greater than 64MB of RAM on the system. Otherwise select “Non-OS/2” setting.
□ Small Logo(EPA) Show
Select EPA (Environmental Protection Agency) Energy Star logo appears during the
system boot-up process.
To Next Page
Loading...