Fein BOP 6 - Page 50

BOP 6 (A); BOP 10 (A); BOP 10-2 (A); BOP 13-2 (A)
7. Fitting
C-SC_CSSM
Version 1.0
2017-10-12
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation.
Page 50 of 65
Fitting the gearbox housing [applies to: BOP 10 (A)]
1. Place the spring washer (1) on the shaft.
2. Position the gear wheel (2).
3. Fit the circlip (3).
 Replace the circlip during each fitting.
4. Press in the shaft (4).
Tools:
- Circlip pliers
- Arbor press
- Sleeve
6 mm inner diameter
20 mm outer diameter
1
2
3
4