Self carrying oil sump screws and engine bracket screws
Thread Nm
M8 35
M10 80
M12 140
M14 200
M16 300
M20 700
M22 700
General torque values
Always use the torque values listed in the following table when specific torque values are not available.
Thread Strength class
8.8 10.9 12.9
M8 25 Nm 35 Nm 40 Nm
M10 50 Nm 75 Nm 85 Nm
M12 85 Nm 125 Nm 145 Nm
M14 135 Nm 200 Nm 235 Nm
M16 210 Nm 310 Nm 365 Nm
Use a washer with the aluminum parts.
1.6.11.3 Coolant quality requirements
AGCO Power Inc. recommends to use coolants that follow in all AGCO POWER engines:
•
Arteco, Havoline XLC
• BASF, Glysantin G30
In addition, coolants under other brand names, which can be proved to use exactly the same inhibitor
package as Arteco Havoline XLC or BASF Glysantin G30, are recommended to be used.
If Arteco Havoline XLC, BASF Glysantin G30 or coolant which uses the same inhibitor package is used, the
coolant change interval can be extended from two years up to five years. If any other coolant is used, the
coolant change interval is two years.
GUID-5C9A453D-3B9B-4DD7-A6D0-BE179CA6E967 [V3]
1. General
1-40 Rubber Track Tractor
79037272A
To Next Page
Loading...
