Fermax 100 CODE MEMOKEY cityline - User Code Operations; Adding or Editing User Codes

To Next Page

To Previous Page

Pag 14

Memokey

1. Disconnect the system’s power supply.

2. Short-circuit the “S2” and ground.

If the system is equipped with a PI exit button, just press

and hold it down (refer to the installation diagram).

3. Reconnect the system’s power supply and remove the

short-circuit (or release the exit button) within 5 seconds.

4. If the process has been carried out correctly a double “beep”

will sound and the green light will stay on. Next enter the

following code A708B9. A double “beep” will sound and

the system will reset itself, restoring its factory settings.

NOTE: The restoration of default factory settings does

not delete the rest of the information programmed on the

system.

Add or Edit User Codes (00 .....99)

The codes are stored in the memory in sequence: position

- code - action. Allows up to 100 access codes be stored.