Fermax 100 CODE MEMOKEY cityline - Changing the Master Code

To Next Page

To Previous Page

Pag 9

Memokey

Changing the Master Code (A0)

The Master code is necessary to enter programming mode.

The equipment is programmed with a default Master code in

factory (1480 by default). The procedure to change it is

the following:

NOTE: If you forget the Master code, you can reset it to the

default code of 1480, as explained in the “Restoring the Master

Code” section.

A master code cannot be a user code and vice versa.

1 Enter programming

mode:

Code Master

(1480)

Bip (3 x)

2 Enter the relevant

option:

Bip (3 x)

3 Indicate the new

Master code:

New Master

Code

Bip (3 x)

Example:

New Master Access

Code for Program-

ming. 1234

1480 A0 1234