Fermax DUOX PLUS - Opening the Door with a Code

Pag 41
Examples:
· Panel congured as Block
Block 25, range of telephones 25XXXX.
· Panel congured as Block + Sub-block
Block 12 / Sub-block 03, range of telephones 1203XX.
· Panel congured as General Entrance
General Entrance, range of telephones XXXXXX (000001 to 999999).
Upon making a call,
· If a Panel is congured as Block it only allows the call to the congured Block (BB).
Block 25, if pressing1 +  the following calling code is generated 250001.
· If a Panel is congured as Block+Sub-block it only allows the call to the congured
Block (BB) and Sub-block (SS).
Block 12 / Sub-block 03, when pressing 1 +  generates the following calling code
120301.
· If the Panel is congured as General Entrance
If you press1 +  you generate the calling code 000001.
Upon making a call, if the selected terminal is in the installation and available (it may be in
conversation with another outdoor panel) it is monitored via a characteristic calling one. If
the marked terminal is not available, a call error tone sounds (beep-bop).
If the number of digits chosen from General Entry is 4 Sub-Block digits are not entered.
For example, to call apartment 24 in sub-block 0 and block 1 the following would be dialled:
- 4 digits: 124
(with 6 digits would have been marked: 10024)
DUOX PLUS has the option of conguring the call from the General Input panel with 4 or
6 digits. The normal operation of the system is equivalent to 6 digits (explained above),
while if 4 digits are selected, those corresponding to the sub-block are not entered when
dialling.
NOTES:
- If a shorter code is entered, it is lled in with “0” to the left.
- Use the ‘A’ key to delete the entered sequence.
- The ‘0’ entered on the left are considered.
- Once the call to a residence is made, and it is proven to exist and not busy, if you press
the  key again a new call is made to the same home. After 30” the last home marked
is not memorised.
Opening the door with a code.
You can enable a lock-release code for all residents. This is a 4 digit code and can be
entered by pressing A when the panel is in stand-by and then the 4 digits.
Opening code: A + XXXX
NOTES:
-This option is deactivated by default. To deactivate the opening code you must enter
the value AAAA in position 08, see “Outdoor panel conguration” on the following page.