Fermax Memokey 100C User Manual

Pag 10
SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Enable user own code change
It is possible to allow the users to change the access code assigned to them for another
personal code. To do this the feature must be enabled.
2. Key in “A 7 “
beep-beep
1480
A 7
3. Key in “1” to enable permit or
Key in “0” to disable it.
1 or 0
beeeep
4. Exit PROGRAMMING mode
beep-beep
A A
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this may be changed if you wish, as shown in this
manual.
NOTE:
99
99
9 Instructions for users to set their own code are given in the User Manual.
Key in “AA” to exit programming mode. System
exits programming mode automatically after 20
seconds inactivity.
Here is how to do it:

Fermax Memokey 100C Specifications

General

Brand	Fermax
Model	Memokey 100C
Category	Security System
Language	English