Fermax Memokey 100C User Manual

Pag 9
SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
NOTE:
99
99
9 If you forget the Master code, it can be replaced by the original 1480, as explained
in this manual.
Change Master Code
The Master Code is needed to enter programming mode. The equipment leaves the
factory with a default Master Code. It can be changed as follows.
2. Key in “A 0 “
See NOTE below
beep-beep
1480
A 0
1. Enter PROGRAMMING mode
Key in the default Master code, 1480
3. Key in new Master Code
The number of digits in the new code must
coincide with the number length set in the system.
MMMM
beeeep
4. Exit PROGRAMMING mode
Key in “AA” to exit program mode.
System also exits programming mode
automatically after 20 seconds inactivity.
beep-beep
A A

Fermax Memokey 100C Specifications

General

Brand	Fermax
Model	Memokey 100C
Category	Security System
Language	English