EasyManua.ls Logo

Ferno 50-E - Using Additional Help

Ferno 50-E
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Ferno-Washington, Inc. 234-3257-01 December, 2004 33
Ferno Model 50-E
7.12 Using Additional Help
Operating the stretcher requires a minimum of one trained operator, but Ferno strongly recommends that the stretcher
be operated by two trained operators. Additional help may be needed when working with heavy loads (patient,
accessories and equipment). Operators should maintain control of the stretcher, operate the controls, and direct
helpers. The chart below shows suggested placement for operators and helpers.
Inspect the stretcher if the load limit has been exceeded (See Inspecting the Stretcher, page 35).
Using the Stretcher
Key: O = Operator H = Helper P = Patient
Changing Levels
Helpers Loading/UnloadingRolling
Two
Operators
+
Four
Helpers
Two
Operators
+
Two
Helpers
Helpers can cause injury. Maintain control of
the stretcher, operate the controls, and direct
all helpers.
WARNING
!
Helpers can be injured. Show helpers where
to grasp the stretcher to avoid pinch points.
WARNING!
LOAD LIMIT
250 kg
S.W.L.
159 kg
S.W.L.
SYSTEM
SAFE WORKING LOAD
STRETCHER TOP
SAFE WORKING LOAD
LOAD LIMIT
Important
The stretcher top Safe Working Load (S.W.L.)
is less than the S.W.L. for the system of
stretcher top and undercarriage. Do not exceed
the S.W.L. limits shown in this manual.

Table of Contents

Related product manuals