5.21
1
2
3
4
5
6
7
8
B
A
Tergicristallo
Per evitare di danneggiare le spazzo-
le evitare l’utilizzo in caso di:
•parabrezza asciutto;
•spazzole incollate al parabrezza per
temperatura sotto zero;
•accenno di neve sul parabrezza e
sui bracci;
•incrostazioni sul cristallo parabrez-
za.
Periodicamente è necessario proce-
dere alla pulizia delle spazzole e ve-
rificarne lo stato di usura.
Sostituzione
Spazzole
•Azionare il tergicristallo e bloccar-
lo (chiave di avviamento in posi-
zione “0”) quando le spazzole (A)
si trovano in posizione verticale.
Windshield Wiper
To avoid damaging the wiper blade,
whenever possible do not use the
wiper under the following conditions:
•when the windshield is dry;
•when the blade sticks to the wind-
shield because of sub-zero tempera-
tures;
•when there are signs of snow on
the windshield or the wiper arm;
• when there are deposits on the wind-
shield.
The wiper blades must be cleaned on
a regular basis and checked for wear.
Replacing the
Wiper Blades
•Turn on the windshield wiper and
lock it in position (turn the ignition
key to position “0”) when the wiper
blade (A) is in a vertical position.
Essuie-glace
Pour éviter d’endommager les balais
d’essuie-glaces, éviter de les utiliser
si:
•le pare-brise est sec;
•les balais sont collés au pare-brise
en cas de gel;
•il y a de la glace sur le pare-brise et
sur les essuie-glaces;
•il y a des impuretés incrustées sur
la vitre du pare-brise.
Il est nécessaire de nettoyer réguliè-
rement les balais d’essuie-glace et d’en
vérifier l’état d’usure.
Remplacement des
Balais d’Essuie-glaces
•Actionner l’essuie-glace et le blo-
quer (clé de contact en position “0”)
quand les balais (A) se trouvent en
position verticale.
Scheibenwischer
Um eine Beschädigung der Wischer-
blätter zu vermeiden, sollten die Schei-
benwischer in folgenden Fällen nicht
eingeschaltet werden:
•bei trockener Windschutzscheibe;
• wenn die Wischerblätter an der Wind-
schutzscheibe festgefroren sind;
•wenn Schnee auf Scheibe und Wi-
scherarmen festgefroren ist;
•wenn die Windschutzscheibe ver-
schmutzt ist.
Die Wischerblätter sollten regelmäßig
gesäubert und auf Verschleiß über-
prüft werden.
Austausch der
Wischerblätter
• Die Scheibenwischer einschalten und
die Zündung ausschalten (Zünd-
schlüssel in Position “0”), wenn die
Wischerarme (A) senkrecht über der
Scheibe stehen.