Festo CMMS-ST-C8-7-G2 Mounting And Installation

CMMS-ST-C8-7-G2
Festo – GDCP-CMMS-ST-G2-HW-EN – 1404NH – English 7
Documentation
Additional information on the motor controllers can be found in the following documentation:
Documentation
Type of
equipment
Table of contents
Mounting and
installation
GDCP-CMMS-AS-G2-HW-... CMMS-AS –Mounting
Itllti
(i
ll ti )
GDCP-CMMD-AS-HW-... CMMD-AS
–
Installation (
p
in allocation)
– Error messages
– technical data
GDCP-CMMS-ST-G2-HW-... CMMS-ST
Functions and
commissioning
GDCP-CMMS/D-FW-... CMMS-AS
CMMD-AS
CMMS-ST
– Control interfaces
– Operating mode s/opera tional
functions
– Commissioning with FCT
– Error messages
STO safety
function
GDCP-CMMS-AS-G2 -S1-. .. CMMS-AS – Functional safety engineering
GDCP-CMMD-AS -S1-. .. CMMD-AS
y
gg
with the safety function STO
(safe torque off ))
GDCP-CMMS-ST-G2-S1-... CMMS-ST
Device profile
FHPP
GDCP-CMMS/D-C-HP-... CMMS-AS
CMMD-AS
CMMS-ST
– Description of the interfaces:
– CAN bus (CANopen)
–InterfaceCAMC-PB
(PROFI BUS)
–InterfaceCAMC-DN
(DeviceNet)
– Control and parameterisation via
the device profile FHPP (Festo
profile for handling and position-
ing) with PROFIBUS, DeviceNet or
CANopen.
Device profile
CiA 402,
GDCP-CMMS/D-C-CO-... CMMS-AS
CMMD-AS
CMMS-ST
– Description of the interface:
– CAN bus ( CANopen, DriveBus)
– Control and parameterisation via
device profile CiA 402 ( DS 402).
Software help Help on the CMMS-AS plug-in CMMS-AS – Surface and functions in the Festo
Help on the CMMD-AS plug-in CMMD-AS
Configuration Tool for the plug-in
Help for the CMMS-ST plug-in CMMS-ST
Tab. 5 Documentation on the motor controllers
The documentation is available on the following media:
– CD-ROM (scope of delivery)
– Support portal: www.festo.com/sp

Festo CMMS-ST-C8-7-G2 Specifications

General

Brand	Festo
Model	CMMS-ST-C8-7-G2
Category	Controller
Language	English