1 Safety and requirements for product use
8 Festo – GDCP-CMMS-ST-G2-HW-EN – 1404NH – English
1 Safety and require ments for product use
1.1 Security
1.1.1 Safety instructions
Caution
Risk of damage to equipment or injury to people from unexpected discharge of con-
densers in motor controller (power approx. 1 Ws). Short circuits can cause sudden dis-
charge of intermediate circuit condensers and e nergy buildup:
– When the module or cover plate is not mounted on the card slot [EXT]
– When c ables are not mounted to the plugs [X6] and [X9]
– When connecting cables a re disconnected when powered.
The produc t must be installed in a control cabinet. The product must not be used until
all safeguardings have been introduced.
Before maintenanc e, repair and cleaning work and when there have been long service
interruptions:
1. Switch off power to the electrical equipment via the mains switch and secure it
against being switched on again.
2. After switch-off, wait at least 1 minute discharge time and chec k that power is
turned off before accessing the controller.
Caution
Danger of burns from hot surfaces
Dependent on t he load of the motor controller, housing temperatures > 80 ° C are pos-
sible in operation.
• Protect hot surfaces from contact in operation.
• Touch them only in a switched-off, cooled-off status.
Note
Danger from unexpected movement of the motor or axis
• Make sure that the movement does not endanger anyone.
• Perform a risk assessment in acc ordance with the EC machinery directive.
• Based on this risk assessment, design the safety system for the entire machine,
taking into account all integrated components. This also includes the electric drives.
Bypassing of safety equipment is impermissible.
To Next Page
Loading...
Need help?
General
