© Festo Didactic GmbH & Co. KG 571861
XI
Allocation of learning objectives and exercises
Exercise 1 2 3 4 5 6
Learning objectives
Become familiar with the safe design or mounting of a stepper motor
system
•
Become familiar with the basic principles of connection technology and
circuit technology of the components used
•
Become familiar with the safe and correct commissioning of a stepper
motor system
•
Become familiar with the basic principles of configuration and
parameterisation of a stepper motor system using the Festo Configuration
Tool (FCT).
•
Be able to set and regulate the speed of a stepper motor system •
Become familiar with the options for setting different acceleration and
braking deceleration speeds using FCT
•
Become familiar with the basic principles of configuration and recording of
measurement data using FCT
•
Be able to carry out homing in a stepper motor system •
Be able to set positions and position records and select positions •
Be able to control the positioning procedures in a stepper motor system
using sequence control
•
Be able to check position records using FCT in a test cycle •
Become familiar with the various operating modes of a motor controller •
Be able to create and control a directional program with position record
linking.
•
Be able to teach in positions. •
Note
For exercise 6, you also need an I/O simulation box and an I/O SysLink cable. These two components are
not included in the equipment set.
To Next Page