© Festo Didactic GmbH & Co. KG 571861
XIII
Notes for the teacher/trainer
Learning objectives
The basic learning objective of this workbook is to become familiar with stepper motors and with the
assembly of a stepper motor system. The combination of both theory and practice ensures faster progress
and longer-lasting learning. The more specific learning objectives aims are documented in the matrix.
Concrete, individual learning objectives are assigned to each exercise.
Required time
The time required for working through the exercises depends on the learner's previous knowledge of the
subject matter. For apprentices in the field of metal working or electrical engineering this is approx. 1 week.
For a skilled worker it is approx. 2 days.
Equipment set components
The workbook and the equipment set match each other. For exercises 1 to 5, you only need the components
included in the equipment set TP 1422. For exercise 6, you also need an I/O simulation box and an I/O
SysLink cable. These two components are not included in the equipment set.
Each exercise can be realised using a slotted mounting frame or slotted profile plate with a width of at least
350 mm.
Designations in the solution sheets
Solutions and supplements in graphics or diagrams are in red.
Designations in the worksheets
Texts which require completion are identified with a grid or grey table cells.
Graphics which require completion include a grid.
Solutions
The solutions specified in this workbook are the results of test measurements. The results of your
measurements can deviate from these data.
To Next Page