sure that there is sufficient ventilation and
connect a mobile dust extractor.
– Check whether there are any signs of
damage to the housing components, such
as cracks or stress whitening. Have any
damaged components repaired before us
ing the power tool.
– Do not use power supply units or third-
party battery packs to operate cordless
power tools. Do not use third-party charg
ers to charge the battery packs. The use of
accessories not expressly authorised by the
manufacturer can result in electric shocks
and/or serious accidents.
2.5 Sawing aluminium
When sawing aluminium, the following meas
ures must be taken for safety reasons:
– Wear protective goggles.
– Connect the power tool to a suitable dust
extractor with an antistatic suction hose.
– Regularly clean dust deposits from the mo
tor housing on the power tool.
– Use an aluminium saw blade.
– When sawing panels, they must be lubrica
ted with petroleum, but thin-walled profiles
(up to 3 mm) can be sawed without lubrica
tion.
2.6 Other risks
In spite of compliance with all relevant design
regulations, dangers may still present them
selves when the power tool is operated, e.g.:
– Touching rotating parts: Saw blade, clamp
ing flange, flange screw,
– Touching live parts while the housing is
open,
– Workpiece parts being thrown off,
– Parts of damaged tools being thrown off,
– Noise emissions,
– Dust emissions.
2.7 Emission levels
The levels determined in accordance
with
EN 62841 are typically:
Sound pressure level L
PA
=
85 dB(A)
Sound power level L
WA
=
98 dB(A)
Uncertainty K = 3 dB
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
CAUTION
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro
tective measures must be defined in order
to protect the operator.
3 Intended use
The
CSC SYS 50 is designed as a transportable
cordless sliding table saw (table saw with inte
grated sliding table) for sawing wood, lamina
ted wooden panels and plastic.
When fitted with the special saw blades offered
by Festool, the machines can also be used for
sawing unhardened ferrous metal and non-fer
rous metal.
It is not recommended for sawing mineral plate
materials such as plasterboard. The abrasive
dust leads to a high level of wear on the electric
drives.
Materials containing asbestos must NOT be
processed.
Do not use cutting or abrasive wheels.
The user is liable for improper or non-in
tended use.
3.1 Saw blades
Only use saw blades with the following dimen
sions:
– Saw blades according to EN 847-1
– Saw blade diameter 168 mm
– Cutting width 1.8 mm
– Locating bore 20 mm
– Standard blade thickness 1.2 mm
– Suitable for speeds of up to 9500 rpm
Festool saw blades comply with EN 847-1.
Only saw materials for which the saw blade in
question has been designed.
Saw blades made of high-alloy high-speed steel
(HSS steel) must not be used.
English
30
To Next Page
Loading...
Need help?
General