Festool DOMINO User Manual

DF 700 DF 700
2120
1
DF 700 Press one or both locking switch to set the routing
depth. Move the routing depth setting slider to the required
routing depth. On the DF 700, the possible routing depth is
between 15 mm and 70 mm. Now release the locking switch–
briefly check that the slider has locked in to position.
TIP The domino should generally be centred
within the joint; that is, the routing depth should
correspond to half of the domino length. However,
depending on the workpiece or joint type, it may
be necessary to locate the domino randomly. In
this case, both of the holes routed in the workpieces
must together correspond to the length of the
domino being used.
Example: The domino being used is 40 mm long;
the left hole is 28 mm deep, the right hole 12 mm
– that is, together 40 mm.
Domino centred
Randomly located domino
TIP You can mark two routing depths using the two green
markers and easily move between the two using the slider.
For example, this can be helpful when using a domino depth
for spacing as well as for repeated, identical routing depths.
40 mm
40 mm
28 mm 12 mm
2016_FES_DOMINO_Book_GB-en.indb 20 03.03.16 12:13

Festool DOMINO Specifications

General

Motor Power	420 W
Dust Extraction Connection Diameter	27 mm
Power Source	Corded Electric
Cutting Depth	15 mm, 20 mm, 25 mm, 28 mm
Cutter Diameter	5 mm, 6 mm, 8 mm, 10 mm