Festool DOMINO User Manual

DF 700 DF 700
DF 500
2322
1
22
DF 700 The routing height is adjusted on the DF 700 equivalent
to the DF 500. The only difference to note: here, the preselect
setting does not determine the board thickness, but instead
the true distance from the top of the workpiece to the centre
of the routed hole.
NOTE The alignment of the clamping levers can be
adjusted by lifting them. In the tightened state, they
should not overhang past the contact surface.
DF 500 – set any routing height
The given dimension defines the distance between the
underside of the leaf and the centre of the routed hole. Loosen
the routing height adjustment clamping lever and, using the
secondary handle, raise the front section of the guide frame.
Then push the slider towards the motor unit until it stops.
Set the required routing height on the scale by moving the
front section of the guide frame horizontally. Now close the
clamping lever.
2016_FES_DOMINO_Book_GB-en.indb 22 03.03.16 12:13

Festool DOMINO Specifications

General

Motor Power	420 W
Dust Extraction Connection Diameter	27 mm
Power Source	Corded Electric
Cutting Depth	15 mm, 20 mm, 25 mm, 28 mm
Cutter Diameter	5 mm, 6 mm, 8 mm, 10 mm