8
9
10 11
12 13
14 15
6362
4
Press the transverse anchor all the way into the routed hole
using the spanner.
Then insert the threaded screw. Tighten it only so that the
screw stays in place, but the opening remains open for the
anchor bolt.
Clip the two DOMINO connector covers around the anchor
bolt. These are used to hold the corner connector flush
against the workpiece.
The transverse anchor is then inserted into the transverse
hole in the side wall, with the screw hole facing upwards.
2016_FES_DOMINO_Book_GB-en.indb 63 03.03.16 12:13
To Next Page
Loading...
