16
17
14
13
15
7372
4
Push both workpieces together ...
... and clamp the connectors by tightening the stud on the
second workpiece side.
TIP In general, these connections are located on the
bottom of tabletops and kitchen worktops, i.e. outside
of visible area. Nevertheless it is possible, of course, to
cover the transverse holes with cover caps.
... and tighten the stud in the first transverse anchor.
Then push the double-headed bolt into the workpiece ...
2016_FES_DOMINO_Book_GB-en.indb 73 03.03.16 12:13
To Next Page
Loading...
