10
Accessories shown or described are sometimes not
included in the scope of delivery.
Intended use
The edge bander is suitable for:
– Attaching edge bands made of wood, materials
similar to wood and plastic using
Festool adhe-
sives
.
Operation
Initial operation
Remove protective foil from underneath the
support base
[1-17]
and display
[1-20]
.
The machine may generate large quantities
of smoke and a pungent odour when operat-
ed for the first time.
Do not use the machine and working materi-
als below 15 °C. Recommendation: room
temperature.
Preparing for operation
Install the support base
[2]
.
Insert the plug into an earthed socket.
Insert a minimum of two adhesive cartridges in
the magazine
(chapter Refilling an adhesive
cartridge [6])
.
Set the heating temperature for the relevant ad-
hesive cartridges.
Temperature selection
[1-7]
according to the de-
fault setting:
Setting 1 = 190 °C
Setting 2 = 200 °C
The temperature can be adjusted by pressing
the menu buttons
[1-19]
(chapter Menu but-
tons [1-19])
. After independent changes are
WARNING
The user bears the responsibility for damage and
accidents caused by improper use; this also in-
cludes damage and wear caused by continuous
use in industry.
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
To Next Page
Loading...
