13
**
Automatic calculation of currently detected edge
height
Dust extraction
An extractor hose with a diameter of 27 mm can be
attached to the extractor connector
[1-6]
.
Working with the machine
Remove the edge band
An edge band was detected
when the machine was switched
on. Request for removal of the
edge band. Press the start but-
ton
[1-1]
and hold until the edge
band has passed through.
Purging position reached
Central plate
[1-12]
has been
lowered completely and moved
to purging position.
Purging process starts
Start button
[1-1]
was pressed.
The purging process starts after
one second.
Purging process is carried out
Adhesive nozzles are open,
pressure has built in the adhe-
sive cartridges. Display of the
current status.
Cooling mode
The machine reduces the tem-
perature in cooling mode and
then switches off. Cooling mode
is activated when:
–on/off switch
[1-8]
is pressed <
1 s
–no controls are actuated for
more than 15 minutes
The machine is switched on
again by pressing the start but-
ton
[1-1]
or the on/off switch
[1-8]
.
190 °C
2
MODE
190 °C
2
180 °C
Fault symbol
Troubleshooting
(chapter Trou-
bleshooting)
.
CAUTION
Vapours emitted during the glueing process!
Ensure there is good ventilation.
Use an extractor.
Always observe national regulations.
WARNING
High temperatures on the heating unit and adhe-
sive nozzle!
Risk of burns when touched
Wear suitable protective gloves.
Always hold the machine by the insulated han-
dles
[1-3]
,
[1-16]
!
WARNING
Moving workpiece!
Risk of injury from sliding workpiece
Always secure the workpiece in such a manner
that it cannot move.
To Next Page
Loading...
