12
Selecting the feed speed
The feed speed can be adjusted and adapted to the
contour of the workpiece at any time by pressing
the button
[1-2]
.
1st gear = 2 m/min
2nd gear = 4 m/min
Menu buttons [1-19]
The following settings can be modified using the
menu buttons
[1-19]
:
– Adhesive quantity
– Setpoint temperature
– Units of measurement
If no menu buttons are pressed within 10
seconds, the menu is closed automatically
and the changes are discarded.
Display [1-20]
The current settings and information graphics are
shown on the display
[1-20]
.
Mode button
Press the button to select the
value you wish to change
(flashes).
Arrow buttons
The selected value can be
adjusted.
OK
Press <OK> to save any
changes.
Temperature selection [1-7]
Setting 1 (190 °C) / Setting 2
(200 °C)
Feed speed[1-2]
1st gear (2 m/min) / 2nd gear (4
m/min)
Units of measurement
Select from °C/m, °C/ft, °F/ft or
°F/m.
°C = degrees Celsius
m = metres
°F = degrees Fahrenheit
ft = feet
2
1
°C/m, °C/ft, °F/ft, °F/m
Remaining edge length
**
Edge band length in relation to
the remaining quantity of adhe-
sive.
Adhesive quantity
Setting for the required adhe-
sive quantity.
Actual and setpoint tempera-
ture
Display
[1-20]
lights up red
during heating mode.
Setpoint temperature
Ready for operation, display
[1-
20]
lights up green.
Refill button [1-21]pressed
Adhesive feed is reversed for
refill process.
Open flap [1-18]
Adhesive feed was reversed for
refill process. Flap
[1-18]
can
be opened.
Insert adhesive cartridges
The magazine can be refilled
with adhesive cartridges.
Close the flap [1-18]
Work can continue after the flap
[1-18]
is closed.
Refill process complete
Adhesive feed moves forward
and pressure builds in the
adhesive cartridges.
Edge inlet ready
Guide the edge band into the
edge inlet
[1-11]
within 20 sec-
onds. The remaining time is dis-
played. If the edge band is not
inserted within the specified
time, the start button
[1-1]
must be pressed again.
Edge band to start position
Now press the start button
[1-1]
to glue the edge band. The
inlet starts up and transports
the edge band through the
machine.
33,0 m
130 190 °C
190 °C
To Next Page
Loading...
