Contents
1 Symbols..................................................... 15
2 Safety warnings.........................................15
3 Intended use..............................................16
4 Technical data........................................... 16
5 Parts of the device.....................................17
6 Battery pack.............................................. 17
7 Transport and storage.............................. 17
8 Commissioning..........................................17
9 Settings......................................................17
10 Working with the electric power tool........19
11 Warning signals.........................................20
12 Service and maintenance..........................20
13 Accessories............................................... 20
14 Environment..............................................21
15 General information..................................21
1 Symbols
Warning of general danger
Warning of electric shock
Read the operating instructions and
safety instructions.
Wear a dust mask.
Wear ear protection.
Wear protective goggles.
Wear protective gloves.
Remove the battery pack.
Inserting the battery pack.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
UKCA marking: The United Kingdom
Conformity Assessed symbol is a
marking for products being placed on
the market in the United Kingdom. It is
a manufacturers indication that the
product is in conformance with the rel
evant regulations in the UK.
Tool contains a chip which stores data.
See section 15.1
Do not dispose of it with domestic
waste.
Tip or advice
Handling instruction
2 Safety warnings
2.1 General power tool safety warnings
WARNING! Read all safety warnings, in
structions, illustrations and specifica
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2 Safety instructions for reciprocating
saws
– Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring. Cutting accessory contact
ing a "live" wire may make exposed metal
parts of the power tool "live" and could give
the operator an electric shock.
– Use clamps or another practical way to se
cure and support the workpiece to a stable
platform. Holding the workpiece by hand or
against your body leaves it unstable and
may lead to loss of control.
2.3 Further safety instructions
– Wait until the power tool has come to a
complete halt before placing it down. The
insertion tool can get caught and lead to a
loss of control of the power tool.
– Deformed or cracked saw blades and saw
blades with blunt or broken cutting edges
must not be used.
– Use appropriate detection devices to look
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
English
15
To Next Page
Loading...
Need help?
General