Fetco CBS-1150 EXTRACTOR V+ - A PROGRAM Details

Go to fetco.com for the latest versions of all information Page 6 P167 March 2018
.
RECIPE Location map
Viewing and changing settings for the brew
recipes is from the “A” screens with the controls
in PROGRAMMING.
The uppermost button positions are permanent
and will not display programming step A_0.
The table above shows in position A20 that a
button position can be made active or inactive.
Position A1 does not display this step
DISPLAY

DISPLAY
STOP
BATCH A1
(permanent)

BATCH A4
(permanent)
BATCH A2

BATCH A5
BATCH A3

BATCH A6
A PROGRAM
Menu Features: Batch Parameters
The settings below are shown for the top batch on a single brewer top left button on a twin brewer.
See how to access all A menus on the previous page. Below are the brew settings for default A1 & A2 batches
POSITION Program Items
Factory set
Default
Programming Range Increments Notes
A11 Batch Volume
1.5 gal
5.65 liters
0.50 to 2.00 gal
1.90 to 7.60L
0.01G
0.05L
Unit software is in liters;
converts to gallon
A12
Brew Time
(MIN:SEC)
4:00 minutes 2:00 – 12:00 0.30
Default total brew time is
5:30 minutes
A13 Prewet Perc. 0% 0.00 – 15.0% 1%
Percentage of total brew
volume
A14
Prewet Delay
(Pause after prewet
completes)
0% [1:00 Min] [0:10 – 5:00] 1:00 min
The time between
prewetting and start of
brew cycle.
This feature appears
ONLY if Prewet >0:00
A16 Drip Delay 1:30 mm:ss 0:30 – 6:00 Min.
Time brew basket should
remain in place during final
drip-out
Drip delay remains “ON” for
1:30 minutes if STOP is
pressed during brew†
A20
BATCH ACT
A20 YES -
NO +
YES
(Active)
Middle and Bottom
batches A2,3,5,6
Batch on
or off
Batches may be
individually enabled,
rewritten or deactivated
A21 Batch Volume
1.5 gal
5.65 liters
0.50 to 2.00 gal
1.90 to 7.60L
0.01G
0.05L
Unit software is in liters;
converts to gallon
A22
Brew Time
(MIN:SEC)
4:00 minutes 2:00 – 12:00 0.30
Default total brew time is
5:30 minutes
A23 Prewet Perc. 0% 0.00 – 15.0% 1%
Percentage of total brew
volume
A24
Prewet Delay
(Pause after prewet
completes)
0% [1:00 Min] [0:10 – 5:00] 1:00 min
The time between
prewetting and start of
brew cycle.
This feature appears
ONLY if Prewet >0:00
A26 Drip Delay 1:30 mm:ss 0:30 – 6:00 Min.
Time brew basket should
remain in place during final
drip-out
Drip delay remains “ON” for
1:30 minutes if STOP is
pressed during brew†
Batch Copy
Copy From Batch
A71
A71 1 (1-6)
Copy To Batch?
A72
A72.1 (1-6)
CBS-1151V+Topmost Batch cannot be disabled. CBS-1152V+Topmost Batch LEFT & RIGHT cannot be disabled.
Middle and bottom batches may be disabled for single and twin brewer (CBS-1151 XV+ and CBS-1152 XV+)
† DRIP DELAY will not activate when STOP is pressed within 5 seconds of starting a brew time
A1
A2
A3
Single Side Models
CBS-1151 V+
STOP
A4
A5
A6
Twin Models
CBS-1152 V+
STOP
A1
A2
A3
STOP