17
ADVANCED PARAMETERS
COLOUR SETTINGS
40. Power load for violet colour
This parameter determines maximum active power value, which when
exceeded, causes the LED ring ash violet. Function is active only when
parameter 41 is set to 1 or 2.
Available settings: 1000-30000 (100.0-3000.0W, step 0.1W)
Default setting:
25000 (2500W)
Parameter size: 2 [bytes]
41. LED ring colour when controlled device is on
When set to 1 or 2, LED ring colour will change depending on active
power and parameter 40. Other colours are set permanently and do
not depend on power consumption.
Available settings: 0 - illumination turned o completely
1 - colour changes continuously depending on
active power
2 - colour changes in steps depending on ac-
tive power
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
Default setting: 1 Parameter size: 1 [byte]
42. LED ring colour when controlled device is o
This parameter denes the illumination colour after turning o.
Available settings: 0 - illumination turned o completely
1 - LED ring is illuminated with a colour corre-
sponding to the last measured power, before
the controlled device was turned o
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
Default setting: 0 Parameter size: 1 [byte]
43. LED ring colour at the Z-Wave network alarm detection
This parameter denes the illumination colour in case of Z-Wave alarm.
Available settings: 0 - illumination turned o completely
1 - no change in colour. LED ring colour is de-
termined by settings of parameters 41 or 42
2 - LED ring ashes red/blue/white
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
Default setting: 2 Parameter size: 1 [byte]
To Next Page
