FIBARO FGWP-102 - Alarm and Response Settings

16
ADVANCED PARAMETERS
24. SWITCH ON value - „On/O” association groups
The value of BASIC SET command frame sent to the devices associat-
ed in „On/O” association groups (2, 3).
„On/O (Button)” association group - in accordance with parameter 20.
„On/O (Power)” association group - in accordance with parameter 23.
Available settings: 0-99 or 255
Default setting: 255 Parameter size: 2 [bytes]
ALARMS
30. Active alarms
Dene Z-Wave network alarms to which the Wall Plug will respond.
Available settings: 1 - general alarm
2 - smoke alarm
4 - CO alarm
8 - CO2 alarm
16 - high temperature alarm
32 - ood alarm
Default setting: 63 (all) Parameter size: 1 [byte]
31. Response to alarm frames
This parameter denes how the Wall Plug will respond to alarms (de-
vice’s status change).
In case of values 1 or 2 the Wall Plug is operating normally and LED
ring signals an alarm through time dened in parameter 32 or until
the alarm is cancelled.
In case of values 5 to 50 the Wall Plug does not report status change,
power changes, ignores BASIC SET command frames. After time de-
ned in parameter 32 or after the alarm cancellation, connected de-
vice is set to the previous state.
Available settings: 0 - no reaction,
1 - turn connected device on
2 - turn connected device o
5-50 (0.5-5.0s, step 0.1s) - cyclically change de-
vice state with set period
Default setting: 0 Parameter size: 1 [byte]
32. Alarm state duration
This parameter species the duration of alarm state. If a device send-
ing an alarm frame through the Z-Wave network sets alarm duration as
well, this settings are ignored.
Available settings: 1-32400 (in seconds)
Default setting: 600 (10min) Parameter size: 2 [bytes]
NOTE
Setting parameter 24
to appropriate value
will result in:
0 - turning o associ-
ated devices
1-99 - forcing level of
associated devices
255 - setting associat-
ed devices to the last
remembered state or
turning them on
i
NOTE
If “Always On” function
is active (parameter 1),
settings of parameter
31 are ignored.
i
NOTE
The alarm may be can-
celled by pressing and
holding the B-button.
i