Wireless ADSL Router User Manual
30
Q: When power supply suddenly turned off or changes, is the configuration be the
same as before?
A:Yes, when you have finished the configuration, you need to press “ Save”
button to save configure parameters. And all the parameters have been saved,
and will not change when power supply turn off or changed. When you configure
some exact parameter, other parameters you set before will not changed either.
Q: PC cannot access the Router?
A: Please make sure that all devices communicating with the device must use the
same channel (and use the same SSID). Otherwise your PC will not find the
wireless Router.
Q: PC cannot access the Internet?
A: First check whether PC can ping the interface Ethernet IP address of this
product successfully (default value is 192.168.1.1) by using ping application. If
ping application fails, please check the connection of Ethernet cable and check
whether the states of LEDs are in gear.
If the PC uses private IP address that is set manually (non-registered legal IP
address), please check:
1. Whether IP address of the PC gateway is legal IP address. Otherwise
please use the right gateway, or set the PC to Obtain an IP address
automatically.
2. Please confirm the validity of DNS server appointed to the PC with ADSL
operator. Otherwise please use the right DNS, or set the PC to Obtain an IP
address automatically.
3. Please make sure you have set the NAT rules and convert private IP
address to legal IP address. IP address range of the PC that you specify should
meet the setting range in NAT rules.
4. Central Office equipment may have problem.
5. The country or the wireless network type you selected is wrong.
Q: PC cannot browse Internet web page?
A: Please make sure DNS server appointed to the PC is correct. You can use
ping application program to test whether the PC can connect to the DNS server of
the ADSL operator.
Q: Initialization of the PVC connection failed?
A: Be sure that cable is connected properly from the DSL port to the wall jack.
The DSL LED on the front panel of the ADSL router should be on. Check that
your VPI, VCI, type of encapsulation and type of multiplexing setting are the same
as what you collected from your service provider, Re-configure ADSL router and
reboot it. If you still cannot work it out, you may need to verify these variables with
the service provider.
To Next Page
Loading...
Need help?
General
