Wireless ADSL Router User Manual
29
power outlet or damaged lines and plugs may cause electric shock or fire
accident. Check the power cords regularly. If you find any damage, replace it at
once.
Proper space left for heat radiation is necessary to avoid any damage caused by
overheating to the device. The long and thin holes on the Access Point are
designed for heat radiation to make sure the device works normally. Don’t cover
these heat radiant holes.
Do not put this device close to a place where a heat source exits or high
temperature occurs. Avoid the device from direct sunshine.
Do not put this device close to a place where is over damp or watery. Do not spill
any fluid on this device.
Do not connect this device to any PC or electronic product, unless our customer
engineer or your broadband provider instructs you to do so, because any wrong
connection may cause any power or fire risk.
Do not putthis device on an unstable surface or support.
9. Appendix: Frequent Asked Questions
Q: None of the LEDs are on when you power on the ADSL router?
A: Please make sure what you use is the power adaptor attached with the ADSL
router package and checks the connection between the AC power and ADSL
router.
Q: DSL LED does not turn on after connect telephone line?
A: Please make sure what you use is the standard telephone line (as attached
with the package), make sure the line is connected correctly and check whether
there is poor contact at each interface. Wait for 30 seconds to allow the ADSL
router establishes connection with you ADSL operator.
Q: DSL LED is in the circulation of slow-flashing and fast-flashing after
connecting telephone line?
A: This situation means the ADSL router is in the status of failing to establish
connection with Central Office. Please check carefully and confirm whether the
ADSL router has been installed correctly.
Q: LAN LED does not turn on after connect Ethernet cable?
A: Please make sure Ethernet cable is connected hub/PC and ADSL router
correctly. Then please make sure the PC/hub have been power on.
Please make sure that you use parallel network cable to connect UpLink port of
hub, or use parallel network cable to connect PC. If connect normal port of hub
(not UpLink port), you must use cross-cable. Please make sure that your network
cables meet the networking requirements above.
To Next Page
Loading...
Need help?
General
