FIFOTRACK Q3 Command List

FIFOTRACK Q3 COMMAND LIST
15
Reply
B26,<err_code>
01 err_code: error code.
OK – Succeed.
UNSUPPORT – Command not supported.
FAILED –Processing failed.
Example
B26,2,HELP
01 Set SMS head string of SOS to “HELP”.
Retrieve
C04,B26,<alm-code>
01 alm-code: Alarm type, refer to Appendix –A. The same as alm-code field in setting
command.
B29 – Setting Sensitivity of Motion Sensor
Source
GPRS/COM/SMS
Description
B29,<mov-stop-level>,<rom-level>
01 mov-stop-level: sensitivity of motion sensor, value [0, 100], default 10; the smaller
value, the higher sensitivity
02 rom-level: sensitivity for reset-on-motion function, range [0,100], default 5; the
smaller value, the higher sensitivity
03 mov-stop-level is used for the judgment of Moving/Stop, “No Movement” detection
04 rom-level is used for reset-on-motion in “Tilt”/”Fall Down” function
Reply
B29,<err_code>
01 err_code: procession error code.
OK – Succeed.
UNSUPPORT – Command not supported.
FAILED – Procession failed.
Example
B29,20
Retrieve
C04,B29
B31 – Setting SOS Number Attribute
Source
GPRS/COM/SMS
Description
B31,<sos-num-idx>,<two-way-call>,<monitor>,<pos-sms>
01 Set SOS number attribute, refer to B11 command for SOS number setting.
02 sos-num-idx: SOS index, value 1, 2, 3, which corresponds to SOS number set by B11
command.
03 two-way-call: attribute of two-way conversation.
04 monitor: attribute of monitor-mode conversation.
05 pos-sms: attribute of position SMS.
06 Description of attributes:
two-way-call: Pressing SOS button to pick up incoming phone-call in two-way
conversation mode.

FIFOTRACK Q3 Specifications

General

Brand	FIFOTRACK
Model	Q3
Category	GPS
Language	English