FIFOTRACK Q3 Command List

FIFOTRACK Q3 COMMAND LIST
18
After cancelled, voice displaying will be stopped, and NO GPRS/SMS alarm package sent;
When rst-on-motion==1, NO pre-alarm voice display, nor fall down alarm triggered under
continuous moving or walking status
05 accl-level: Acceleration level for fall down detection, default 55, range [20,60]
06 “Fall Down” alarm code 31. Refer to Appendix-A for more detail
Reply
B36,<err_code>
01 err_code: procession error code.
OK – Succeed.
UNSUPPORT – Command not supported.
FAILED – Procession failed.
Example
B36,1,30,20,1
01 Enable fall down detection, after fall down detected, tracker starts voice displaying to
remind user. It will send out GPRS/SMS alarm package after 20s, but will continue voice
displaying till 30s time is up.
During the pre-alarm period, shaking/walking/pressing SOS button will cancel pre-alarm
and alarm trigger delay
Retrieve
C04,B36
B70 – Setting the Functions to Button
Source
GPRS/COM/SMS
Description
B70,<hangup>,<pwroff-disable>,<long-key-voice>
01 hangup: 1~Press SOS button to hang up phone-call conversation; 0 (default)~Disable
hang-up function of SOS button
02 pwroff-disable: 1~PWR button cannot be used to shut down device; 0 (default)~Long
press PWR button can shut down device
03 long-key-voice: 1 (default)~Display voice when long press SOS or CAL button; 0~No
voice displaying for long press SOS and CAL button
Reply
B70,<err_code>
01 err_code: procession error code.
OK – Succeed.
UNSUPPORT – Command not supported.
FAILED – Procession failed.
Example
Retrieve
C04,B70
B71 – Setting GPS/WIFI Order
Source
GPRS/COM/SMS
Description
B71,<mode>
01 Device supports two methods for positioning, GPS and WIFI, and B71 command is
used to set the order of use

FIFOTRACK Q3 Specifications

General

Brand	FIFOTRACK
Model	Q3
Category	GPS
Language	English