7. Day / Night Mode 2. Override into Night Mode
This function allows the user to override any pre-programmed Day / Night timing information
and force the system into the more sensitive Night Mode. This will cause the panel buzzer to
sound and a disablement to be written to log.
7. Day Night Mode 3. End all Overrides
This function ends any override on the Day / Night Mode, and all programmed actions are
reinstated. The control panel event log will indicate that all actions have been reinstated
7. Day Night Mode 4. View Day / Night Setting
This function allows the user to view the start and finish times for each day.
This function allows the user to switch on the LED and sounder (if they are present) at any
device on the loop in order to aid in locating its position. It cannot be used to turn on the LED
of I/O Modules, since this would also turn on the output which would not usually be desirable.
Up, Down and Esc options allow the adjacent devices to be located, and the test to be ended.
To Next Page
Loading...
